company news about How to Assemble a Krone Disconnection Module

Strip about 2-3 cm (1 inch) of the outer jacket from the cable using a cable stripper.

Untwist the wire pairs and arrange them according to the color-coding scheme (usually following T568A or T568B standards).

Open the Krone module (if it has a cover) or align the wires with the Insulation Displacement Connector (IDC) slots.

Place each wire into its corresponding slot (ensure correct pairing):

Use a Krone punch-down tool to press each wire firmly into its slot.

The tool will cut excess wire and ensure a gas-tight connection.

Ensure all wires are fully seated and no strands are sticking out.

If the module has a protective cover, close it to protect the connections.

If mounting on a patch panel or distribution frame, snap or screw it into place.

Use a cable tester to verify continuity and correct wiring.

Check for cross-talk or loose connections if signal issues occur.